News

Reporting the news, progress and other happenings at CPV Manufacturing, Inc.

Mark VIII fittings from CPV. Always a perfect match with your system.

The design of Mark VIII O-Seal fittings assures leakproof connections in gases or liquids up to 6000 psi. The union connections in this system are flatfaced with a resilient O-ring incorporated into a close tolerance groove on one side of the body. Low torquing of the union nut compresses the O-ring to seal the connection.

These fittings make it easier, faster and more economical to change out gauges or other components that require regular replacement. They are available in couplings, tees, elbows, crosses and reducers in sizes from 1/4" to 2" OD. CPV also offers a complete system of valves (shutoff, needle, check and relief) to compliment the Mark VIII O-Seal fittings.

Mark VIII fittings can be heat sealed into a system by welding, orbital welding or brazing. Brazing can be done with elementary tools and requires very little training. The test data and photos to the right demonstrate the durability of Mark VIII O-Seal Fittings when they are brazed to brass, copper, steel and stainless steel tubing with a hand held propane torch. Each tubing section was hand-tight assembled on the end of a hydraulic pump before pressurization.

In every case the tubing failed before the Mark VIII O-Seal Fittings. In fact, the burst pressures of 9,000 to 16,000 psi substantially exceeded the 6000 psi rated pressure of these Mark VIII O-Seal Fittings.

CPV has been a leading manufacturer of valves and fittings since 1915. The company's innovative designs are well suited to standard applications, as well as one-of-a-kind custom requirements.

For more information or technical literature on O-Seal valves or other CPV Valves & Fittings contact:
Charles J. Horter
Sales and Marketing Manager
CPV Manufacturing, Inc.
851 Preston Street,
Philadelphia, PA 19104–1598
Phone: (215) 386-6508, ext.244
Toll free: (888) 386-2211
Fax: (215) 387-9043